Optotronic OT 80 220V 24V DIM IP67 LED power supply supplies drivers

Nominal voltage 220 - 240 V
Mains frequency 50 - 60 Hz
Input voltage AC 198 - 264 V
Power factor λ 0.90/0.95
ECG efficiency 87%
Device power loss 12 W
Power loss in stand-by mode < 1.5w Inrush current 35 A
Max. ECG no. on circuit breaker 10 A (B) 7
Max. ECG no. on circuit breaker 16 A (B) 10
Surge capability (L-N) 3 kV
Nominal output voltage 24 V
Nominal output power 80 W
Galvanic isolation primary/secondary 3.75 kV
Length 250 mm
Width 50 mm
Height 34 mm
Mounting hole spacing, width 14 mm
Cable cross-section, input side 1 mm²
Cable cross-section, output side 1.5 mm²
Wire preparation length, input side 10…11 mm
Wire preparation length, output side 10…11 mm
Casing material Metal
Ambient temperature range –25…+55 °C
Maximum temperature at tc test point 80 °C
Max.housing temperature in case of fault 100 °C
Temperature range at storage –40…85 °C
ECG lifetime 50000 h
Dimmable Yes
Dimming interface 1…10 V
Dimming range 1…100%
Overheating protection Automatic reversible
Overload protection Automatic reversible
Short-circuit protection Automatic reversible
No-load proof Yes
Max. cable length to lamp/Led module 10m
Suitable for fixtures with prot. class II
Approval marks - approval CE / CB / C-Tick
Standards Acc. to IEC 61347-1/Acc. to IEC 61347-2-13/Acc. to IEC 62384/Acc. to CISPR 15/Acc. to IEC 61000 - 3-2/Acc. to IEC 61000 - 3-3/Acc. to IEC 61547
Type of protection IP67
Temperature range at storage –40…85 °C
Relative humidity 5…85%

Benefits
• Versatile 1-10 V wide-range driver up to 240 W due to flexible output characteristics
• Very high efficiency and reliability
• High IP protection (IP67)
• High surge protection: up to 3 kV (L-N) / 6 kV (L/N-PE)

Areas of application
• Suitable for use in tight, flat luminaires or installation in suspended ceilings
• Suitable for indoor and outdoor SELV installations

Features
• Dimmable via fully isolated 1…10 V interface
• Driver with output power range of up to 240 W

General safety informations