519795 | Manufacturer: Osram | EAN: 4008321519795 | MPN: OTE-13-220-240-SD-DIM
Optotronic ote 13 220V 350mA SD DIM LED drivers efficient power
More info
Nominal voltage 220 - 240 V
Mains frequency 50 - 60 Hz
Input voltage AC 198 - 264 V
Power factor λ 0.90
ECG efficiency 82%
Device power loss 2.4 W
Power loss in stand-by mode < 1 W
Inrush current 16 A
Surge capability (L/N-Ground) 2 kV
Surge capability (L-N) 1 kV
Nominal output voltage 34 V
Nominal output current 350 mA
Nominal output power 12 W
Galvanic isolation primary/secondary 3.75 kV
Length 182 mm
Width 41 mm
Height 28 mm
Cable cross-section, input side 0.5-1 mm²
Cable cross-section, output side 0.5-1 mm²
Wire preparation length, input side 8.0…11 mm
Wire preparation length, output side 8.0…11 mm
Ambient temperature range –20…+55 °C
Maximum temperature at tc test point 70 °C
Max.housing temperature in case of fault 80 °C
Temperature range at storage –40…85 °C
ECG lifetime 50000 h
Dimmable Yes
Dimming interface StepDIM (By external switch or digital PIR sensor)
Dimming range 50 / 100%
Overheating protection Automatic reversible
Overload protection Automatic reversible
Short-circuit protection Automatic reversible
No-load proof Yes
Max. cable length to lamp/Led module 5.0m
Suitable for fixtures with prot. class I
Standards Acc. to IEC 61347-1/Acc. to IEC 61347-2-13/Acc. to IEC 62384/Acc. to IEC 61000 - 3-2/Acc. to IEC 61000 - 3-3/Acc. to IEC 61547/Acc. to CISPR 15
Type of protection IP20
Temperature range at storage –40…85 °C
Relative humidity 5…85%
Features
• SELV equivalent
• 2 output channels
• StepDIM interface: switch between two predefined output currents
• Slim housing with separate plug terminals
