PT FIT 35 220 240 HID electronic ballasts

Osram PT FIT 35 220 240 HID electronic ballasts I Ballast. Upgrade your lighting with the PT FIT 35 220 240 I HID electronic ballast. Experience brighter, more efficient illumination for space.

Lamp wattage 39 W
Line current 0.19 A
Ignition voltage 4.5 kVp
Operating frequency 0200…0.240 kHz
System wattage 42.5 W
ECG efficiency 92%
Input voltage 220 - 240 V
Voltage range 198 - 264 V
Mains frequency 50 - 60 Hz
Power factor λ N/A
Inrush current 30 A
Max. no. of ECGs on circuit breaker 10 A 15
Max. no. of ECGs on circuit breaker 16 A 26
Max. no. of ECGs on 16 A MCB with EBN-OS 65
Protective conductor current 0.3 mA
U-OUT 250 V
Max. working voltage between LH and LL 250 V
Max. working voltage betw. LL/LH andamp; earth 250 V
Max. capacitance of wire ECG/lamp 120 pF
Length 171 mm
Width 83 mm
Height 32 mm
Mounting hole spacing, length 163 mm
Cable cross-section, input side 0.75-1.5 / 0.75-2.5 mm²
Cable cross-section, output side 0.75-1.5 / 0.75-2.5 mm²
Wire preparation length, input side 5.5…6.5 mm
Wire preparation length, output side 5.5…6.5 mm
Casing material Plastic
Ambient temperature range –15…+60 °C
Maximum temperature at tc test point 75 °C
ECG lifetime 30000 h
Design / version With cable clamp
System guarantee level 3c
Maximum wiring length ECG/lamp 1.5m
Overheating protection Power reduction and switch off at T > 75 °C at the tc point
ECG reset time > 0.5s
Cable types, input side NYM-J 3 × 1.5 / NYM-J 3 × 2.5 / H05 VV-F 3 × 1.5 / NHXMH-J 3 × 1.5 mm²
Cable types, output side SIHF-J 3 × 1.5 / SIHF-J 3 × 2.5 / SIHSI 3 × 1 mm²
Dimmable No
Restriction on ignition time 20 min
Suitable for fixtures with prot. class I
Approval marks - approval VDE / VDE-EMC / GHOST / C-Tick
Type of protection IP20
EEI - Energy Label A2
Standards acc. to EN 61347-2-12/acc. to EN 55015/acc. to EN 61000 - 3-2/acc. to EN 61547/acc. to EN 62493

Benefits
• ECG with ergonomic strain relief for correct installation in suspended ceilings
• Optimized cost/benefit factor
• Automatic safety shutdown of lamps in the event of a defect or at end of life (EoL)

Areas of application
• Shop lighting
• Health and fitness areas
• Effect and accent lighting

General safety informations