Philips HID AV C 35 70/I 220V CDM

Lamp Type CDM
Number Of Lamps 1 piece/unit
Suitable For Outdoor Use No
Number Of Products On MCB (16 A Type B) 58
Automatic Restart Yes
Input Voltage 220 - 240 V
Input Frequency 50 - 60 Hz
Minimum Mains Voltage Operation (Min) 198 V
Power Factor 100% Load 0.95
Ignition Voltage (Max) 5 kV
Ignition Voltage (Min) 3 kV
Ignition Switch-Off Time 19 min
Mains Voltage Performance (AC) 198-254 V
Mains Voltage Safety (AC) 180-264 V
Earth Leakage Current (Max) 250 mA
Inrush Current Width 10m s
Lamp Power Tolerance -3% /+3%
Inrush Current Peak (Max) 8 A
Cable Capacity Output Wires Mutual 160 pF
Cable Length From Device To Lamp 2 m
Wire Striplength 10 - 11 mm
Ballast Contact Wire Cross Section 0.75-2.50 mm²
Connector Type WAGO series 804
Rated Ballast-Lamp Power 35-70 W
Lamp Power On CDM 39-73 W
Power Loss On CDM 5 - 7 W
T-Ambient (Max) 45 °C
T-Ambient (Min) –20 °C
T-Storage (Max) 80 °C
T-Storage (Min) -25 °C
T-Case Lifetime 80 °C
Housing -I
Length A1 189.2 mm
Fixing Hole Distance Length A2 170.7 mm
Width B1 83.5 mm
Height C1 34.7 mm
Fixing Hole Diameter D1 4.8 mm
• SOFT START allows installation with fewer circuit breakers; Loop Through allows faster, cost-efficient installation
• Longer lifetime
• Driver can be set to 35, 50 or 70 W with the integrated switch, which means there is no need to replace the driver if the installation requires lower or higher-wattage lamps in the future

Features
• SOFT START
• Loop Through (in independent version)
• Improved thermal performance
• Low electromagnetic interference
• Voltage drop detection

Applications
• Accent and decorative lighting for shops, public spaces, lobbies and offices
• Suitable for indoor use only

General safety informations