Osram QTi DALI 2x35-49W 220-240V DIM T5 Quicktronic intelligent








QUICKTRONIC INTELLIGENT DALI DIM T5. Elektronska predatikalna naprava za T5 fluorescenčne sijalke.

Več podatkov

43,30€brez DDV

Teža: 0.4 kg
Dostava: 1 do 3 dni
Stanje: Nov izdelek

- +

  0 / 5 - 0 komentarjev  Dodaj komentar

Input voltage AC 198…264V
Nominal voltage 220…240V
Mains frequency 50…60 Hz
Input voltage DC 154…276V
Operating frequency 44…120 kHz
Max. ECG no. on circuit breaker 10 A (B) 8
Max. ECG no. on circuit breaker 16 A (B) 13
Power loss in stand-by mode 0.2W
Inrush current 45 A

Starting time 0.6 s

Length 423.0 mm
Width 30.0 mm
Height 21.0 mm
Mounting hole spacing, length 415.0 mm
Wire preparation length, input side 8.0…9.0 mm
Wire preparation length, output side 8.0…9.0 mm
Cable cross-section, output side 0.5…1.5 / 0.5…1.0 mm2
Cable cross-section, input side 0.5…1.5 / 0.5…1.0 mm2

Ambient temperature range +10…+50 °C

ECG lifetime 100000 h

Dimming interface DALI / Touch DIM / Touch DIM Sensor
Dimming range 1…100 %
Dimmable Yes
Overload protection Yes
Overheating protection Power reduction and switch off at T > 75 °C at the tc point
Suitable for fixtures with prot. class I
End of lamp life safety shutdown EOL T.2

Approval marks – approval VDE / VDE-EMC / ENEC 10 / EL / GOST / RCM / CCC / E1 approval
EEI – Energy Label A1 BAT
Standards Acc. to EN 61347-2-3/Acc. to EN 60929/Acc. to EN 55015:2006 + A1:2007/Acc. to EN 61000-3-2/Acc. to EN 61547
Protection class I
Type of protection IP20

Product benefits
-Easy integration in luminaire thanks to same dimensions like DALI GI ECG
-Touch DIM function for easy and inexpensive dimming of several ECGs
-Same luminous flux with direct and alternating current
-Dimming of amalgam lamps without flickering or reduced lifespan
-Automatic restart after lamp replacement
-No new approvals required

DALI product features
-Control via the DALI interface
-Compliance with the DALI standard to IEC 60929 and IEC 62386
-Control input protected against overvoltage and polarity reversal (OSRAM ECG)

Touch DIM and Touch DIM Sensor function
-Manual dimming without controller and with standard switches
-Including memory function (double click) and soft start

Areas of application
-Suitable for use in emergency lighting systems as per EN 50172/DIN VDE 0108-100
-Installation in emergency lighting systems according to IEC 61347-2-3, appendix J
-Open-plan offices, corridors and storage rooms
-Public buildings
-Sports halls and factories
-Strip lighting
-Shop lighting

Product features
-Corridor function for direct connection of ECG to common motion sensor
-Corridor function with pre-programmed light program
-Touch DIM function for free parameterization of light value and turn on time
-Fit for SMART GRID for feedback of consumed mains power and lamp operating hours
-Fit for Emergency function for automatic detection of emergency lighting by ECG
-Very low standby power consumption: < 0.2 W (A1 BAT)
-Lifetime: up to 100,000 h (temperature at Tc = 65 °C, max. 10 % failure rate)
-Very high number of switching cycles: up to 300,000
-Dimming range: 1…100 % (3…100 % with compact fluorescent lamp)
-POWER2LAMP function for optimal matching of ECG power to lamp during lamp lifetime

Osram QTi DALI 2x35-49W 220-240V DIM T5 Quicktronic intelligent 4050300870465 QTI-DALI-2-35-49

Tehnični podatki
Možnost zatemnitveDa
Napetost - volt (V)220-240
Mednarodna oznaka zaščite - (IPXX)IP20
Življenska doba - ure (h)100000
Tovarniško pakiranje - kosov (kos)20
Komentarji (0)
Skupna ocena:
Temelji na 0 komentarjev

Vprašanja o izdelku (0)

Postavi vprašanje

Vprašanje bo prikazano po pregledu naše ekipe.

Baza znanja

  • Ali dostavljate v tujino?

    Da, dostavljamo v tujino. V EU, ZDA in tudi v vse ostale dele sveta. Za dostavo uporabljamo preverjene in zanesljive dostavne servise.


0 Primerjaj