QUICKTRONIC® DE LUXE DIMMABLE This high-frequency electronic control gear enables T8 fluorescent lamps to be dimmed from 100% to 1% of their luminous flux via a 1
10V DC interface. The 1 ... 10 V interface allows a wide variety of possible connections, ranging from simple manual controls for small systems through daylight-controlled regulation systems to modern energy management systems with PC and digital I-bus technology. QUICKTRONIC® DE LUXE DIMMABLE goes beyond all current conventional and electronic solutions not just in terms of lighting comfort and energy consumption, but also in simplicity of operation and installation. Comfort:
Dimmable from 100% to 1% luminous flux (T8 fluorescent lamps), from 100% to 1.7% for OSRAM DULUX® L
Flicker-free starting at any dimmer setting throughout the temperature range
Numerous control options with a low-voltage control signal (1-10V) -·Electronic control gear from different circuits can be dimmed together on different phases
Easy to incorporate into existing lighting control systems
No disconcerting harmonics as there are when phase dimmers are used Economy:
Impressive energy savings thanks to high-frequency operation. Large additional potential energy savings through daylight-dependent lighting control
Longer lamp life
Protective warm start within 0.5 s Safety:
Safety shutdown of lamps in the event of a defect or at end of life
Complies with European standards for safety, operation and EMC
Overvoltage protective circuit for short-duration voltage surges (DIN VDE 0160) and for temporary overvoltages
Greater safety thanks to low equipment temperatures
Suitable for use in emergency lighting systems to DIN VDE 0108 Applications: Adjustable lighting in conference rooms, film projection rooms, exhibition rooms, CAD and PC rooms, control rooms, film recording studios, and for energy savings in offices with daylight-dependent lighting control General:
Supply voltage: 230 V to 240 V
Mains frequency: 0, 50 to 60 Hz
Lamp start: warm start within 0.5 s, lamp start from any dimmer setting
Same luminous flux with direct and alternating current
We recommend that you allow new lamps to burn in for at least 100 hours at 100% luminous flux. The battery voltage may drop to 154 V. The lamps must be ignited at over 198 V
Automatic restart of replacement lamps
ENEC VDE, EMV
Safety to EN 60928
Lamp operation to EN 60929
RI suppression: to EN 55015
Mains harmonics: to EN 61000-3-2
Immunity: to EN 61547